Clicker
12-31-2009, 12:20 PM
Is there a way to melt the solder and burn off the acid flux portion so you could use the tin. I have a couple of rolls of the stuff and was hoping to use it up during a bullet casting session.
I was under the impression that using this type of solder/flux combo was not a good idea when added into your alloy.
I do have a small iron crucible type pot I could use just for such a "smelt". It's no great loss if it's not practical to do this just thought I'd ask.
I was under the impression that using this type of solder/flux combo was not a good idea when added into your alloy.
I do have a small iron crucible type pot I could use just for such a "smelt". It's no great loss if it's not practical to do this just thought I'd ask.