550 utube video question?

[DssG19]

Are both of those guys setting up the 550 on utube installing the powder failsafe bar wrong. They both look like they insert the bar from right to left into the powder measure linkage. In the instructions it shows inserting the bar from left to right. I tried the utube way and the failsafe bar kept jumping out and jamming up the linkage. I looked at the instructions(should have followed first) and switched it around and it works fine. Are these guys f'd up or am I crazy?

[Phunahm]

Theres only one way it should go..they way I use is with the end of the rod face outwards If I put it in the other way it hit the hopper bottom...

[DssG19]

Theres only one way it should go..they way I use is with the end of the rod face outwards If I put it in the other way it hit the hopper bottom...

That is the incorrect way, per the instructions right? I'm looking at the cover of te instruction manual and it shows it fed through the larger part(leftside) that you pinch together with the smaller piece facing inward.

[Phunahm]

umm I'm not home, but if i put mine inward it hits the hopper

[freakshow10mm]

This is the correct way.

http://img.photobucket.com/albums/v239/freakshow10mm/Handloading/DSC02999.jpg

[Steve Koski]

FS knows EVERYTHING.

[DssG19]

This is the correct way.

http://img.photobucket.com/albums/v239/freakshow10mm/Handloading/DSC02999.jpg

+1 the you tube folks look like they put in in the oppisite way. Another reason to follow the directions.

[Phunahm]

This is the correct way.

http://img.photobucket.com/albums/v239/freakshow10mm/Handloading/DSC02999.jpg
Thats how I have mine :patriot:

[freakshow10mm]

FS knows EVERYTHING.
No, just some things.:cornut:

[unclebob]

It would have been nice if the guy in the video new what he was doing.

[DssG19]

ok im not crazy, I watched both of those fools put it in wrong. Monkey see, monkey do. read the instructions and got it straighten out.