Cartridge collection brack issue with 550B...my fault.

[callahan318]

Dillon Issue...

I put the cartridge collection bin bracket next to the press, and when setting the screw, the bracket move so it is flush to just under the platform on the 550B. Do I need to pull it out and give it that full 1/8 of an inch of clearance or can I leave it?

[freakshow10mm]

Put a case or round in the shellplate and swing it over to station 4. Hold the cartridge chute where you think it should be and index the plate to make the round drop. If it goes in the bin, put it right there. That's how I did it.

[Gashira]

Put a case or round in the shellplate and swing it over to station 4. Hold the cartridge chute where you think it should be and index the plate to make the round drop. If it goes in the bin, put it right there. That's how I did it.

+1. You're fine as long as the round falls into the bin each time.