Redding G-RX 40S&W Die

[Steviewonder1]

Just got one of these to full length case size range brass that was fired in a Unsupported Glock Barrel. Installed it, adjusted as noted, and the brass comes out the top ready to size and load. The full length sizing gets rid of the bulge near the bottom of the case. You can then shoot it in any barrel glock included or an aftermarket barrel. Cost was $42.99. You still have to size it to get the neck tension right to hold the bullet.
Works GREAT and is recommended for your bench.

[VN350X10]

Wonder how long it will take them to bring out the 9mm version.
With a lot of shooters going to "9 Major" in open, the need is already there.
note here: Yes, you can make 9 Major out of a stock Glock 34 barrel, I've been doing it for about 4 years, testing & chronoing loads both at the range & in matches. Works fine.

uncle albert


:68: